STEP 1

You must first determine what IP address it received. To do this, you need to pick up the phone attached to the Line 1 jack and dial:

                         **** (four asterisks)

then dial:

and you will be told the IP address of your device (e.g. 192.168.0.100)

STEP 2

Go to any browser equipped computer on your network and enter the address: http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

STEP 3

Click on the "Admin Login" button near the top right side of the screen, then click on the "Line 1" tab.

STEP 4

You need to modify only a few parameters from the factory default. They are listed here:

Enter the password that you chose when you signed up for FonoSIP.com service.

STEP 5

To save bandwidth, you can change Line 1 "Preferred Codec" to G729a. You can only do this for one line. So, if Line 1 is on G.729a, Line 2 has to be some other codecs. We do not support G.723.

STEP 6

Click on the "Save Settings " button at the bottom of the form.

STEP 7

Make calls!

Behind NAT

If you get one-way audio, you are probably behind NAT. Make the following changes on LINE 1 (you have to click on advanced view to see these options)

Behind NAT

On the SIP menu